Middle TN - Thread

[reddozen]

Originally Posted by Johnny_K

man it should look good after body work,

Could you not use the rotors that came with your engine?

and i thought you was going with haltech?

I could have used the stock rotors, but they're 9.1, and I wanted higher compression since it was NA, so we got a set of 9.7.

The new Adaptronic is plug and play with the RX8 including the CAN bus systems. It also supports up to a 4 rotor. So all I have to do is re-wire 2 of the RX8 AUX valves to run the 2 extra ignition channels, and I don't even have to change out the engine harness to run the 20b. It's a $4k cut out of the budget for now. I'll pretty it up a little more later. Right now, I'm more worried about either running out of money, or it not being done in time.