Go Back   Rotary Car Club > Tech Discussion > Show your rotary car build up.

Show your rotary car build up. Show off your Rotary Car build!

Reply
 
Thread Tools Display Modes
Old 03-29-2018, 07:55 AM   #1
infernosg
IT'S ALIVE!
 
infernosg's Avatar
 
Join Date: Dec 2009
Location: Richmond, VA
Posts: 811
Rep Power: 16
infernosg is on a distinguished road
There is a chance, yes. I got the new seat installed and the old seat switched over to the passenger's side. I just need to drill a hole in the floor for the fifth point.

I've ordered new rear bearings for the transmission. I figure since I'm already going to be in there replacing the front bearings I should replace the rear as well. I'm not planning on replacing the center bearings since that requires near complete disassembly of the transmission. I plan on re-checking the clearances and have ordered new washers just in case anything is out. Hopefully that'll fix the neutral and 4th gear noise I'm getting and maybe even fix the vibration in 5th. The plan is to have all this done by 4/20 and I still need to check the front wheel bearings...
infernosg is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:33 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com