Lighter = Faster (N/A build thread #2)

[vex]

Originally Posted by infernosg

Sooo... I'm an idiot. The bearings are fine. The spindles are fine. I pulled the driver's side wheel and before messing with the bearings again I decided to give the strut a good tug - "thunk." It turns out the play was in the suspension. The lower locking ring of the coilover was just loose enough to allow the strut body to move inside the threaded tube. I had checked this and I wasn't able to tighten/loosen the ring by hand so I'd assumed it was good. I further torqued the ring using the adjustment tool and a plastic hammer. Boom - no more play.

I decided to replace the bearing seals while I was in there anyway. When I did the bearings on Sunday I reused the old ones because I couldn't get the pre-load low enough with the new seals. This time I threw the pre-load instructions out the window and gradually tightened the spindle nut, with the brake rotor and wheel bolted on, until all play was gone.

At least it wasn't an improperly mounted wheel on the spindle.