Gasket Descriptions

[BLKTOPTRVL]

I did a little experiment today.

I took a shot of this gasket...

http://rotarycarclub.com/showpost.ph...27&postcount=4

Then adjusted the size of the photo so that the dimensions match, printed it out.

What I got was a almost perfect match for the original gasket. The photograph still needs a little adjustment to match the original exactly.

Of course this is just one test, but I believe that using good photography, and software I can easilly produce new gaskets of the correct size. Then using the cutting machine produce good duplicates.

I am going to try a few after the machine arrives and see how close I can get them.