|
RX-7 3rd Gen Specific (1993-2002) RX-7 1993-2002 Discussion including performance modifications and Technical Support Sections. |
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
The Judge
Join Date: Feb 2008
Posts: 196
Rep Power: 18 ![]() |
This is how I have my Blitz EBC hooked up after trying another way.
It works perfectly with no spiking. Pressure source for the EBC unit comes from the rear of the UIM near the map sensor source. You want the two to read equal pressures. Pressure source for the side of the wastegate and for the solenoid "in" comes from the TB elbow which has been tapped and "Teed". This pressure is closer to the pressure for the EBC and map sensor and less than before the IC. The solenoid out goes to the top of the WG. I use a 10lb WG spring and run 11, 13, 15, 16 psi boost as my EBC has four settings. |
![]() |
![]() |
![]() |
Bookmarks |
|
|