FS: NIB WORK MEISTER 3piece wheels

[Pourman]

NICE !! ... was looking at Gram Light 57S Pro Titanium , but these are 2nd on my list ... wonder if these would fit with Border front fenders at that width / offset ??

[fikren]

Originally Posted by Pourman

NICE !! ... was looking at Gram Light 57S Pro Titanium , but these are 2nd on my list ... wonder if these would fit with Border front fenders at that width / offset ??

Not real sure. They were going to be used with the burnout kit so rishie at autoRnD crunched his numbers and this was as close as he could figure without actually test fitting wheels and various tires. They were sized for the tire size I wanted to run and for the wheel and edge of the fenders to line up so that they did not sit inside the fenders if looking down or stick out some rediculous ammount. Some of it will depend on suspension setup and tire size, stretch or not, etc. To much stuff for me to figure out plus if they weren't spot on perfect I wasn't concerned as the plans were to get rubber on the wheels and send them with the car to the body shop so that it all fit so its possible a little bit of work would have had to be done for it to be spot perfect. If you can find out the size differences on the Border and the Burnout and do alittle bit of diggin you may be able to find out for sure.

Thanks for the replies guys. These are definatly sexy wheels and if it were not for some circumstances I have going on right now these would not be up for sale. Even when I was posting my project car for sale I was still planning on keeping the wheels and worse case do some rx-8 modifications to make them fit on it. As far as being an inch wider, if I had known I was going to be selling them without ever using them, I would have ordered them an inch wider just for you guys. Unfortunatly they were ordered based on the plans I had and sizes I wanted to run so thats why on 11's.

On another note, if anyone is local and either interested in them or willing to help a friend out, arrangements can be made to fit them on a similar car if that helps anyone out. No rubber but should be able to jack the car throw one on then jack the suspension alittle to get to ride height. Wouldn't be spot perfect but should give a pretty damn close idea where any problems or work would be needed to fit your application.

Let me know if anyone needs any more info or pictures of them. Those pictures above were taken the day they showed up and they have been boxed ever since but I got no problems taking some more if needed.

Thanks,
Jonathan