Go Back   Rotary Car Club > Tech Discussion > Show your rotary car build up.

Show your rotary car build up. Show off your Rotary Car build!

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 06-27-2009, 01:17 AM   #10
vex
RCC Loves Me Not You
 
vex's Avatar
 
Join Date: Jul 2008
Location: Influx.
Posts: 2,113
Rep Power: 20
vex will become famous soon enough
Quote:
Originally Posted by FC3S Murray View Post
Ha, I actually measured them bro. Front rotor slots all measured between 2.01-2.04mm. The bad rear rotor had one side with 2.03-2.05 BUT the other side of the rotor measured 2.15-2.18.

No good in my opinion. However, I can not find specs on the wear limits. ONly specs when Apex seal is installed via FSM.
Usually the apex seals vary a little in thickness and hence why the FSM has it using the seals as part of the measurements. Check the seals and see what the dimensions of them are. You'd be surprised and might find a few that measure 2.03mm maybe more if they were exceptionally sloppy.
vex is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:14 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com