|
|||||||
| Interior, Stereo, Body kits, etc... Place where you could talk about car care, body kits, painting your car, Carbon Fiber, Thumping Stereo, etc.. |
 |
|
|
Thread Tools | Display Modes |
|
|||||||
| Interior, Stereo, Body kits, etc... Place where you could talk about car care, body kits, painting your car, Carbon Fiber, Thumping Stereo, etc.. |
|
|
|
Thread Tools | Display Modes |
01-30-2011, 07:45 PM
|
#1 |
|
MG rocket
Join Date: Oct 2010
Location: Victoria Australia
Posts: 40
Rep Power: 0  |
Basic gauge wiring question
Hi,
I have purchased a Autometer 4337M Water Temp Gauge and have an install question re the wiring. I think (hope) it will be simple and able to complete without the aid of an Auto Elecrician. In short, I am replacing a crappy WT gauge that displays degrees F - very inaccurately. The new gauge (Degrees C) comes with the Autometer sender. The old sender has 2 "posts" and the new has 1 only. The instructions claim the sender is grounded by the thread. Can someone make comment based on the attachment. Please note, I need to retain the "auto switch on function" of the thermo fan with this new gauge. (Car is a MG Midget with 13B N/A) THANK YOU! |
|
|
|
02-09-2011, 04:15 AM
|
#2 |
|
MG rocket
Join Date: Oct 2010
Location: Victoria Australia
Posts: 40
Rep Power: 0 |
Problem sorted...
Previous gauge was reading from a second sender....!!! |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
