S4 and S5 non turbo engine part out and misc FC stuff, P&P TB

Fidelity101 · 12-06-2009, 10:36 PM

Okay first off I have tons of S4 intake manifolds with actuators and inserts laying around and I wanna get rid of them. They will be going to the scrap yard soon so I'm offering 8 dollars + shipping for any S4 intake manifold (lower or upper)

I have an S5 LIM with actuators and flow friendly sleeves that mimic the pineapple racing inserts for
15 dollars + shipping

13b FC Eccentric shaft with new pilot bearing and dust seal installed

50 shipped

I also have a set of S5 NA injectors for 75 dollars shipped, 2 of them are missing lower grommets but they are in good shape.

also have an 86-91 logicon aka hvac controller with the harness cut 20 shipped

S5 NA ported and polished throttle body, TB mod has been done so there is no thermowax and shows roughly double gain in airflow. includes the TB gasket and TPS, you can use this on an S4 setup if you are running premix or using standalone ECU that requires a wideband TPS signal, other wise to run on S4 electronics you have to make a connector and only utilize the narrowband TPS signal

80 dollars shipped

I also have a pair of S5 NA 9.7:1 non turbo engine rotors that have been cleaned

perfect shape and pulled from a running motor
asking 165 shipped for the pair

get em before they go on ebay!!!!

the TB is already there but can be taken down easily and I get throttle bodies semi infrequently so be patient and I will have some more S4 and S5 TBs

http://cgi.ebay.com/ebaymotors/ws/eB...CA:MOTORS:1123

I have some misc S4 and S5 NA irons that I will sell cheap, some may need to be lapped but they are still within spec, measured for warpage already and checked with a dial indicator for step wear

I still haven't taken apart another S4 NA motor so let me know what you may want and I'll let you know if it is usable or not

paypal ready and verified

part located in central MI

Fidelity101 · 12-07-2009, 01:26 AM

injectors sold!

Fidelity101 · 12-07-2009, 11:40 AM

TB sold, rotors pending

more s4 and s5 NA TBs for P&P to come though

Shadow24v · 03-09-2010, 10:15 PM

Are those s5 n/a rotors still around or did they sell earlier?

need RX7 · 03-09-2010, 10:41 PM

Still have the S5 LIM? I'll likely buy it if you do.

David Jerome · 03-10-2010, 04:38 PM

Ill take the e-shaft if it is in good shape. Pm me the paypal info.

David

j_tso · 03-13-2010, 10:34 AM

This thread was made about 4 months ago, has anyone had replies?

I'm interested in an S4 lower intake.

need RX7 · 03-16-2010, 01:43 AM

Still interested in the S5 LIM if you have it.

Looks like the OP has been around in the last couple days.
# Last Activity: 03-14-2010 04:28 PM

j_tso · 03-16-2010, 06:10 PM

He replied to my PMs quickly.

12-06-2009, 10:36 PM	#1
Fidelity101 Reliable Source Join Date: Nov 2008 Location: Michigan/Illinois Posts: 336 Rep Power: 17	S4 and S5 non turbo engine part out and misc FC stuff, P&P TB Okay first off I have tons of S4 intake manifolds with actuators and inserts laying around and I wanna get rid of them. They will be going to the scrap yard soon so I'm offering 8 dollars + shipping for any S4 intake manifold (lower or upper) I have an S5 LIM with actuators and flow friendly sleeves that mimic the pineapple racing inserts for 15 dollars + shipping 13b FC Eccentric shaft with new pilot bearing and dust seal installed 50 shipped I also have a set of S5 NA injectors for 75 dollars shipped, 2 of them are missing lower grommets but they are in good shape. also have an 86-91 logicon aka hvac controller with the harness cut 20 shipped S5 NA ported and polished throttle body, TB mod has been done so there is no thermowax and shows roughly double gain in airflow. includes the TB gasket and TPS, you can use this on an S4 setup if you are running premix or using standalone ECU that requires a wideband TPS signal, other wise to run on S4 electronics you have to make a connector and only utilize the narrowband TPS signal 80 dollars shipped I also have a pair of S5 NA 9.7:1 non turbo engine rotors that have been cleaned perfect shape and pulled from a running motor asking 165 shipped for the pair get em before they go on ebay!!!! the TB is already there but can be taken down easily and I get throttle bodies semi infrequently so be patient and I will have some more S4 and S5 TBs http://cgi.ebay.com/ebaymotors/ws/eB...CA:MOTORS:1123 I have some misc S4 and S5 NA irons that I will sell cheap, some may need to be lapped but they are still within spec, measured for warpage already and checked with a dial indicator for step wear I still haven't taken apart another S4 NA motor so let me know what you may want and I'll let you know if it is usable or not paypal ready and verified part located in central MI __________________ My Rx-7 Vids Last edited by Fidelity101; 12-06-2009 at 10:42 PM.

12-07-2009, 01:26 AM	#2
Fidelity101 Reliable Source Join Date: Nov 2008 Location: Michigan/Illinois Posts: 336 Rep Power: 17	injectors sold! __________________ My Rx-7 Vids

12-07-2009, 11:40 AM	#3
Fidelity101 Reliable Source Join Date: Nov 2008 Location: Michigan/Illinois Posts: 336 Rep Power: 17	TB sold, rotors pending more s4 and s5 NA TBs for P&P to come though __________________ My Rx-7 Vids

03-09-2010, 10:41 PM	#5
need RX7 Clean S4 Nutswinger Join Date: Mar 2008 Location: Sterling Heights, MI Posts: 485 Rep Power: 18	Still have the S5 LIM? I'll likely buy it if you do. __________________ -Ted -1986 Mazda RX7 Sport [DD/beater]: engine finally let go at 205k. parts car status. -1986 Mazda RX7 base [resto-mod project]: S5 n/a swap in progress.

03-10-2010, 04:38 PM	#6
David Jerome RCC Contributor Join Date: Jan 2008 Posts: 713 Rep Power: 18	Ill take the e-shaft if it is in good shape. Pm me the paypal info. David __________________ David Jerome Broker for Speed For Sale LLC (David@SpeedForSale.com) (Pre-owned RX7/sports car sales & new parts sales/installs/tuning) PM me about low priced, high quality port work

03-09-2010, 10:15 PM	#4
Shadow24v Rotary Fan in Training Join Date: Feb 2009 Posts: 69 Rep Power: 17	Are those s5 n/a rotors still around or did they sell earlier?

03-13-2010, 10:34 AM	#7
j_tso Rotary Fan in Training Join Date: Mar 2008 Posts: 65 Rep Power: 18	This thread was made about 4 months ago, has anyone had replies? I'm interested in an S4 lower intake.

03-16-2010, 01:43 AM	#8
need RX7 Clean S4 Nutswinger Join Date: Mar 2008 Location: Sterling Heights, MI Posts: 485 Rep Power: 18	Still interested in the S5 LIM if you have it. Looks like the OP has been around in the last couple days. # Last Activity: 03-14-2010 04:28 PM __________________ -Ted -1986 Mazda RX7 Sport [DD/beater]: engine finally let go at 205k. parts car status. -1986 Mazda RX7 base [resto-mod project]: S5 n/a swap in progress.

03-16-2010, 06:10 PM	#9
j_tso Rotary Fan in Training Join Date: Mar 2008 Posts: 65 Rep Power: 18	He replied to my PMs quickly.