Quote:
Originally Posted by RETed
One problem with the beam-type is that parallax can be a problem.
Depending on gradiation, you could be off by as much as 5 lb-ft in some cases...
This is why I asked what #'s were you shooting for.
If you're trying to shoot for 25 lb-ft, if we account for possible parallax error, it could be as low as 20 lb-ft...
20 lb-ft is a bit too low for most rebuilders.
-Ted
|
IRRC I did the tension bolts to 30lbs. I was very thorough in checking them repeatedly. As you tighten them it lessens the torque on the ones tightened before the most recent. I went back through and checked them a few times.
I may do a little experiment. I may buy both a cheap Harbor Freight clicker as well as a Craftsman. I've got some spare trashed n/a irons. I may find a spot to tighten a bolt down with all 3 wrenches and see how much variance there is. Maybe just do a nut on an exhaust stud?
__________________
Quote:
|
Originally Posted by yzf-r1
Take your pathetic ultimatums and stupid "AOL" comments and shove them straight up your ass, you little punk. You avatar is gay as well....
|
1990 Vert/ S5-JDM 13BT (rebuilt but with issues I'm working out). Rtek N370 1.7, 550/800 injectors, FD fuel pump, RB REV TII exhaust, Tein springs and Illuminas
01-26-2013, 01:59 AM
Threaded Mode