Go Back   Rotary Car Club > Tech Discussion > Show your rotary car build up.

Show your rotary car build up. Show off your Rotary Car build!

Reply
 
Thread Tools Display Modes
Old 02-13-2010, 02:10 PM   #1
djmtsu
My minds tellin' me no...
 
djmtsu's Avatar
 
Join Date: Feb 2008
Location: Murfreesboro, TN
Posts: 4,043
Rep Power: 22
djmtsu will become famous soon enough
OHhhhhhh bad news.

So I took out the injectors. Rear primary injector was barely firing. So I bought a new gasket and got some new injectors. This morning, I out everything back in. Fired it up.

Still ran like shit. It was idling fine, and revved free, but just sounded bad.

I noticed when I fired it up, the oil pressure seemed lower than normal (45-50psi compared to normally it pushed 75-80psi). Not good.

So I let it warm up. Came back 10 minutes later, checked the pressure gauge, barely registering 5psi. Revved it, went to just below 25psi and dropped to maybe 10psi while the RPM's were up. Pretty sure it spun a bearing.

Oh well. Time to figure out whether to part it out, or sell it as a whole. It does run, and can be driven......if you were a brave soul.

Oh well, I guess its the RX-8 to DGRR after all.
__________________
1976 Mazda Cosmo RX-5
1976 Mazda Cosmo RX-5
2003 Toyota Tundra TRD
2015 Toyota 4Runner SR5
djmtsu is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:38 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com