3 Rotor FB build - "Silvie II"

ducktape · 02-06-2011, 01:27 AM

This thread isn't dead!

After being out of work for almost a year, I had some financial obligations to take care of. So this project didn't really pick up steam until November. I've been taking pics since then, but haven't posted. The goal is to have it rolling this summer. Going to miss DGRR, but there will be other events.

As it stands the 20b is at LMS-EFI for port work. I have the LIM and UIM, and am prepping them for powdercoat. I've selected my transmission: Liberty Tremec TKO 600 5-speed with the faceplate option. Really doing my homework on gear ratios, and taking measurements to fit. Based on what I have learned, I think I may need to move the motor back another 2-3 inhes. This tranny would fit perfectly in the stock position if you could put the shifter in the middle of the dash. :P

02-06-2011, 01:27 AM	#11
ducktape Hardcore Join Date: Apr 2010 Location: Louisville, Ky Posts: 88 Rep Power: 16	This thread isn't dead! After being out of work for almost a year, I had some financial obligations to take care of. So this project didn't really pick up steam until November. I've been taking pics since then, but haven't posted. The goal is to have it rolling this summer. Going to miss DGRR, but there will be other events. As it stands the 20b is at LMS-EFI for port work. I have the LIM and UIM, and am prepping them for powdercoat. I've selected my transmission: Liberty Tremec TKO 600 5-speed with the faceplate option. Really doing my homework on gear ratios, and taking measurements to fit. Based on what I have learned, I think I may need to move the motor back another 2-3 inhes. This tranny would fit perfectly in the stock position if you could put the shifter in the middle of the dash. :P