|
Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
Thread Tools | Display Modes |
![]() |
#20 |
Don Mega
Join Date: Dec 2008
Location: Utopia
Posts: 1,688
Rep Power: 18 ![]() |
http://v.youku.com/v_show/id_XMjM1ODc1OTIw.html
^ Here is a good video showing the great balance of the RX7 You see how much power you need in a great car, V's a over rated DATSUN to achieve good velocity on the straights. pay particular note to how far out DATSUN speedo's are to proper velocity measures from the VBOX data logger, and also check to see how long it takes to go 100kmh to 200kmh for the 3 DATSUNS ![]() And here is the power plot of it below on a dynapack, it lacks a bit for mid range power, but non the less shows it can be good (so long as the exhaust does not catch on fire after 3 laps!) http://translate.google.com.au/trans...6prmd%3Divnsfd Taking off the 1.15 trans mission guess (TCF multiplier) factor it makes a peak BLIP of 547Ps on 1.51kg/cm boost pressure & a more average 478PS subtracting the BLIP power peak! < power at the hubs!!! (roughly same power at much higher boost than what I made on my old Yellow First gen in 2002! > http://www.riceracing.com.au/water-injection.htm ![]() ![]() ![]()
__________________
www.riceracing.com.au Worlds best Apex Seals Coil on Plug Water Injection ECU Calibration Last edited by RICE RACING; 03-26-2011 at 06:25 PM. |
![]() |
![]() |
Bookmarks |
|
|