Plain Jane OEM nothing to see here rebuild

[JustJeff]

Originally Posted by Pete_89T2

Maybe I'm missing something from an earlier post. Your schematic diagram shows a 2 wire fan motor (just + and - terminals), but you also said it was a 3 wire Taurus fan. Where is the 3rd wire in this diagram, and is this motor grounded or does it have a floating ground?

Sounds like I might have assumed too much. I assumed difference between 2 wire and 3 wire Taurus fans was that 2 wire was 1 speed and 3 wire was 2 speed. I also assumed that for my 3 wire fan that I had one common ground and 2 different +. + for low and + for high. I assumed that the diagram was for either high or low, but not for both. I physically swap wires to go from high to low. I never have all 3 wires connected at one time. I also assumed the ground was common (to engine, chasis, etc), but I don't really understand floating grounds. I've done some light reading and so far it escapes me. My best understanding of floating grounds are car speakers. Each speaker is not grounded to the chasis. They are grounded via the amp.

It's been a while since the car has been sitting and I wired in the fan and relay. I'll let you know where the fan is grounded a little later today/tonight...after I dig into the wiring.