FC Lower arm bar

[Turbo II Rotor]

Originally Posted by Raksj04

Could you post more pics?

Sure thing Rich. I still need to pull it back off and paint it, bare metal rusts with the quickness here in the north east. I made it with the cross tube short enough to fit a socket up on the inside bolt. I used 3/16 plate and traced out the control arm bucket over top, cut it out and welded it to the inside. I then bolted the mounts to the car, measured and cut my 1 1/2" square tube to 24 1/4", hammered it in and welded it in place. I also drilled and tapped the buckets for a zerk fitting so I can grease my delrin bushings on the car.

Flux core FTL. I need to set up an argon tank for my welder.

Originally Posted by TitaniumTT

Specifically of the engine bay