My RX7SP build up

RICE RACING · 01-04-2015, 12:56 AM

More optimization!

Fuck it would be impossible without this CAD though!
Also never attempt to do this without some parts on hand LOL did the spring and fastener mount then went and checked some torx screws I have in stock they are 1.8mm with 3.48mm head and I cant even pick them in my hand LOL!!!!

making the spring would have been a nightmare

Revised !

Shit is starting to look good now, not far to go in design process then will start making the c-u-n-t-s ~!

01-04-2015, 12:56 AM	#1
RICE RACING Don Mega Join Date: Dec 2008 Location: Utopia Posts: 1,688 Rep Power: 18	More optimization! Fuck it would be impossible without this CAD though! Also never attempt to do this without some parts on hand LOL did the spring and fastener mount then went and checked some torx screws I have in stock they are 1.8mm with 3.48mm head and I cant even pick them in my hand LOL!!!! making the spring would have been a nightmare Revised ! Shit is starting to look good now, not far to go in design process then will start making the c-u-n-t-s ~! __________________ www.riceracing.com.au Worlds best Apex Seals Coil on Plug Water Injection ECU Calibration Last edited by RICE RACING; 01-04-2015 at 01:17 AM.