Go Back   Rotary Car Club > Tech Discussion > Show your rotary car build up.

Show your rotary car build up. Show off your Rotary Car build!

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 06-26-2014, 12:10 AM   #11
GySgtFrank
Professional Stick Poker
 
GySgtFrank's Avatar
 
Join Date: Feb 2011
Location: Stafford, Ks.
Posts: 1,012
Rep Power: 16
GySgtFrank will become famous soon enough
I got the suspension bolted back in. I had to make a bunch of studs for the adjustment boxes which took a fair bit of time. Went in with no problems for a change and left me just slightly negative of zero camber at the full out position. I was trying for zero, but I got about .2 of a degree negative. Close enough. I haven't checked caster yet, but the eyeball-o-meter says it's pretty close as well.

suspension back in 1 by GySgtFrank, on Flickr

suspension back in 2 by GySgtFrank, on Flickr

And surprise, surprise, the tires actually center in the openings this time. I did wipe it down for the photo, it was getting pretty grimy from sitting on stands for so long. Next check all measurements again and get the coilovers mounted. Then finish the lower K member or vice versa, either way.

suspension back in - side shot 2 by GySgtFrank, on Flickr

I had to put in a second shot 'cuz I'm liking the side view sitting at ride height. This was the look I was trying for.

suspension back in - side shot 1 by GySgtFrank, on Flickr
__________________
1988 N/A SE 2+2, dead stock and staying that way.
1979 SA22C stock? Not so much.
http://rotarycarclub.com/rotary_foru...ad.php?t=15585
GySgtFrank is offline  
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:25 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com