|
Show your rotary car build up. Show off your Rotary Car build! |
|
Thread Tools | Display Modes |
![]() |
#11 | |
IT'S ALIVE!
Join Date: Dec 2009
Location: Richmond, VA
Posts: 811
Rep Power: 16 ![]() |
Quote:
Small update today. Got the steering rack centered and installed this weeked: ![]() I think I've have actually gained a little extra steering angle. I reattached the outer tie rods to my previous marks and the hubs were definitely pointing off to the driver's side. I re-centered the rack by measuring the total displacement and splitting the difference of one of the inner tie rods. Perhaps the piston on the rack also acted like a stop? I test fit the rear wheels with the car on the ground. I'm going to need a little more camber and some small fender work: ![]() ![]() Nothing a roller and some time won't fix. After that I played around with the front splitter. This thing is going to take a lot of work to look halfway decent: ![]() ![]() ![]() Basically it's 2-3 inches too wide at the front wheels and seems uneven from side-to-side. According to ISC-Racing this is the quality of a "race part" I should expect. Maybe it'll fit better with the bumper cover actually mounted and not held on with duct tape and once I notch the splitter for the stock fender bolts. That won't happen until I get the other fiberglass pieces in and get everything lined up. |
|
![]() |
Bookmarks |
|
|