Go Back   Rotary Car Club > Tech Discussion > Show your rotary car build up.

Show your rotary car build up. Show off your Rotary Car build!

Reply
 
Thread Tools Display Modes
Old 02-28-2009, 01:57 PM   #1
Fidelity101
Reliable Source
 
Fidelity101's Avatar
 
Join Date: Nov 2008
Location: Michigan/Illinois
Posts: 336
Rep Power: 17
Fidelity101 is on a distinguished road
Quote:
Originally Posted by Low Impedance View Post
eh they are probably about the same. They are pretty much the same Type M transmission. 12a is a bit shorter ratio and also physically shorter. I could do the tail shaft swap but there is no need to for now.

I have a MS unit but for cost reasons, im going with the stock stuff for now. Then once i get my MS up and running ill convert.
I did the swapping the tail shaft and spedo worm gear but it was the 13b 1st gen trans. I recommend it, my car isn't fast but I just need it to get up to speed so it helps, I also wish I had a 4.30 instead of a 4.10 but it would make 1st gear even more useless.
__________________

My Rx-7 Vids
Fidelity101 is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:50 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com